Bombardier SeaDoo 2001 factory shop manual, Page 265Get this manual
Section 06 ENGINE MANAGEMENT (DI) Subsection 04 (DIAGNOSTIC PROCEDURES)
FAULT DETECTION AND COMPENSATORY ACTIONS
For basic overview of the monitoring system and the limp home modes, see OVERVIEW section
COMPONENT FAILURE WARNING SYSTEM
Sensor Failures
Refers to open or short circuit failures on sensors, drivers, injectors or ignitionPROBLEM Manifold air pressure sensor (MAPS) Manifold air temperature sensor (MATS) Throttle position sensor (single TPS) Water temperature sensor (WTS) Direct injector (single injector) Fuel injector (single injector) Ignition (no firing on one cylinder) RAVE solenoid Starter solenoid Fuel pump Exhaust gas temperature sensor (EGT) Fuel level sensor Diagnostic cap fault Knock sensor Engine drowned mode activated (it is not fault) INFO CENTER "MAINT" RED LED ON BUZZER OFF BUZZER CODE LIMP HOME MODE Limited RPM