Bombardier SeaDoo 2001 factory shop manual, Page 244Get this manual
Section 06 ENGINE MANAGEMENT (DI) Subsection 03 (COMPONENT INSPECTION AND ADJUSTMENT)
ELECTRONIC MANAGEMENT MPEM REPLACEMENT
General
Prior to replacing suspected MPEM, ensure that all the recommendations in the general introduction of this section have been followedIMPORTANT: When MPEM is replaced, the safety lanyard(s), the TPS closed position and the TDC setting must be reprogrammedresetRefer to their specific section for adjustmentTo allow transferring the previous recorded information from the old MPEM to the new one, use the vehicle communication kit (VCK) with the B.U.D.SsoftwareUse Replace in the MPEM menuFollows instructions in its help systemNOTE: If the old MPEM is working, it must be read inside B.U.D.Sprior to removing it from the vehicle to carry vehicle information and history to the new MPEMBesides, select the Setting tab and note the Current Angle in the ignition offset areaWhen installing the new MPEM, re-use this setting as preliminary settingThen, proceed with the regular procedure for the TDC settingIf the old MPEM is not working, try to find previous saved file from B.U.D.S