Bombardier SeaDoo 2001 factory shop manual, Page 207Get this manual
Section 05 ENGINE MANAGEMENT (RFI) Subsection 04 (COMPONENT INSPECTION)
Using multimeter, check the resistance between terminal (WHITEBLUE wire) and terminal (BLACKBLUE wire) on the plug connector
RAVE SOLENOID
F07F15F
F07D0GA
The resistance should be between 3.4 and 8.2 kCheck also the resistance between terminal (BLACKBLUE wire) and terminal (PURPLE BLUE wire) of the plug connectorThe resistance should be between 2.4 and 8.2 kIf not within specification, disconnect the connector of the water temperature sensor and check resistance of wiring harness and terminals between AMP plug connector and APS sensor connectorReconnect the air pressure sensor connector and recheck the resistance value between terminals in the AMP plug connector number 4If not within specification, replace the air temperature sensor