Bombardier SeaDoo 2001 factory shop manual, Page 204Get this manual
Section 05 ENGINE MANAGEMENT (RFI) Subsection 04 (COMPONENT INSPECTION)
The resistance should be between 710 and 1380
CRANKSHAFT POSITION SENSOR (CPS)
Check the resistance of the crankshaft position sensorF07F15B
F07H0CA
If resistance is below specifications, replace the throttle position sensor (TPS)If resistance is above specifications, disconnect the connector of the throttle position sensor and check resistance of wiring harness and terminals between AMP plug connector and TPS sensor connectorIf there is an open circuit, repair or replace the defective wire or terminalReconnect the throttle position sensor connector and recheck resistance values at AMP plug connector number 4If not within specification, replace the throttle position sensorNOTE: Whenever the TPS is replaced, removed or adjusted, the TPS closed position must be readjusted