Bombardier SeaDoo 2001 factory shop manual, Page 128Get this manual
Section 04 ENGINE Subsection 05 (TOP END)
To easily slide cylinder block over pistons, use ring compressor (PN 290 876 965)
Torque screws in criss-cross sequence for each cylinder to 20 Nm (15 lbfft)Repeat the procedure, retightening all cylinder screws to 40 Nm (30 lbfft)2 2
A01B1TA
1Slide this edge
NOTE: For each ring, make sure to align ring end gap with piston locating pinInstall cylinder blockApply Molykote 111 on O-ring no31 and install itCAUTION: The O-rings must be installed and properly positioned in the cylinder blockThe O-rings are meant to dampen stud vibration
F01D7FA