Bombardier SeaDoo 2001 factory shop manual, Page 123Get this manual
Section 04 ENGINE Subsection 05 (TOP END)
All RAVE-Equipped Engines There is only one way to insert the sliding valve no22 in valve housing no25
Push needle bearing together with inner halves out of the locating sleeve into the connecting rod bore Replace the inner halves by the appropriate sleeve tool in the connecting rod bore Insert piston pin into piston until it comes flush with inward edge of piston hub Warm piston to approximately 5060C (122 140F) and install it over connecting rodNOTE: Make sure thrust washers are present each side of needles Install the shoulder sleeve tool on the opposite side of the piston pin1 2
F06D12A
1Sliding valve ridge toward housing groove
At assembly, place the pistons no3 with the letters "AUS" (over an arrow on the piston dome) facing in direction of the exhaust port