Bombardier SeaDoo 2001 factory shop manual, Page 101Get this manual
Section 04 ENGINE Subsection 04 (MAGNETO SYSTEM)
Rotor and Ring Gear
Apply Loctite 648 (green) on mating surface of the rotor no8When reinstalling rotor to ring gear no3, one of the protrusion end of rotor must be aligned with hole in ring gear1 2
Install flywheel and make sure to align keyway with the crankshaft Woodruff keyApply Loctite 243 (blue) on nut no13Install nut with lock washer and torque to 115 Nm (85 lbfft)CAUTION: Never use any type of impact wrenchUnlock crankshaftReinstall pulse fitting with washer and torque to 19 Nm (14 lbfft)
Before installation, properly install O-ring no25 in engine magneto cover no1Apply Loctite 767 anti-seize compound on screws no11Torque screws in criss-cross sequence to Nm (80 lbfin)DI Models If heat exchanger cover has been removed, ensure to align its notch with the emboss in casing.F15D01A