Bombardier SeaDoo 2001 factory shop manual, Page 92Get this manual
Section 04 ENGINE Subsection 04 (MAGNETO SYSTEM)
The following procedure is to find common reference point on both crankcases (old and new) to position armature plateProceed as follows: Before removing the armature plate, find crankcase locating lug (the top one in this example) Place cold chisel at the end of chosen lug, then punch mark on armature plate at this point3 2
F01D4CA
1Puller plate 2Puller 3Extension handle
Lay magneto flywheel no2 on steel plateTap lightly on ring gear no3 using hammer to release it from magneto flywheel1
F01D4DA
1Crankcase locating lug 2Mark armature plate at the end of lug
At assembly, align armature plate mark (previously punched) with the end of the corresponding locating lug on the new crankcase1 2