Bombardier SeaDoo 2001 factory shop manual, Page 16Get this manual
INTRODUCTION
1Clean threads (stud and hole) with solvent2Apply Loctite Primer (PN 293 800 041) on threads and allow to dry3Put several drops of proper strength Loctite threadlocker on female threads and in hole4Apply several drops of proper strength Loctite on stud threads5Install stud6Install cover, etc7Apply drops of proper strength Loctite on uncovered threads8Tighten nuts as required
Adjusting Screw
Preassembled Parts
A00A3PA
1Apply here 2Plunger
1Adjust screw to proper setting2Apply drops of proper strength Loctite threadlocker on screwbody contact surfaces3Avoid touching metal with tip of flaskNOTE: If it is difficult to readjust, heat screw with soldering iron (232C (450F))