Bombardier SeaDoo 2000 factory shop manual volume 2, Page 327Get this manual
Subsection 02
Section 12 HULLBODY (ADJUSTMENT AND REPAIR)
Inside Wipe down the area with acetone on clothApply the same procedure as for outside repair when laminating the alternating pieces of fiberglass materialIf backing support was used, remove it before starting the repairAfter the area has hardened, remove sharp edges of material from surfaceIf required paint the surfaceSANDING Outside This surface will have to be prepared for application of gelcoatThe size of the area will determine the gelcoating procedure to be usedRefer to the repair procedure for minor gelcoat fracturesBUFFING AND WAXING Refer to the buffing and waxing for Minor Gelcoat Fractures
Materials
fiberglass mat fiberglass cloth polyester resin cardboard masking tape sandpaper (100-grit, 220-grit, 320-grit, 400-grit, 600-grit, 1000-grit) 24-grit sanding disks Bombardier gelcoat putty Bombardier liquid gelcoat acetone cabosil epoxy filler medium compound (white) fine compound (white) wax