Bombardier SeaDoo 2000 factory shop manual volume 2, Page 320Get this manual
Section 12 HULLBODY Subsection 02 (ADJUSTMENT AND REPAIR)
RX Models Place the mirror frame in hot water to "soften" the material to allow mirror installation in its frame
All Models
RIDING PLATE
Removal
Remove inlet grateRemove jet pumpRefer to JET PUMPRemove the speed sensor from the riding plate (if applicable)Loosen riding plate screwsNOTE: An impact screwdriver should be used to loosen tight screwsUsing low height hydraulic bottle jack and steel plates, pry out riding plate
INLET GRATE
All Models
Removal and Installation
Loosen screws and remove inlet grateNOTE: An impact screwdriver should be used to loosen tight screwsWhen reinstalling inlet grate, apply Loctite 271 on threads and torque screws to 11 Nm (8 lbfft)RXRX DI models Follow this sequence referring to the illustration: Hand tighten screw numbersthen Torque screw numbers and to 11 Nm (97 lbfin)Torque screw number to 26 Nm (19 lbfft)