Bombardier SeaDoo 2000 factory shop manual volume 2, Page 292Get this manual
Section 10 PROPULSION SYSTEM Subsection 05 (VARIABLE TRIM SYSTEM)
INSPECTION
Make sure boot no3 is in good conditionIf it is cracked or teared, replace boot
Install motor, worm and sliding shaft in VTS housing
Inspect threads and splines of worm no9 for wearIf worm replacement is necessary, renew also sliding shaft
F01J2GA
Install and torque nuts no11 to Nm (62 Ibfin)Connect wires of motorCAUTION: Make sure wire color codes matchInstall cover no7NOTE: Make sure seal no12 is in placeF01J25A
1Inspect threads and splines
INSTALLATION
Installation is essentially the reverse of removal proceduresHowever pay particular attention to the following