Bombardier SeaDoo 2000 factory shop manual volume 2, Page 281Get this manual
Section 10 PROPULSION SYSTEM Subsection 03 (DRIVE SYSTEM)
To verify the preload of the boot no10, proceed as follows: NOTE: To verify the boot preload and free length, jet pump and drive shaft must be installedMeasure boot length when normally installed on drive shaftEnsure circlip no5 is properly installed into groove
Subtract the installed length measurement from the free length measurementA difference of mm to 12 mm (532 in to 1532 in) should be obtainedIf the length is less than mm (532 in), install spacer (PN 293 250 017) between boot and thru hull fittingF00J04B
F00J03A
1Spacer
1Boot AMeasure here
NOTE: Drive shaft must be removed to install spacer
Push floating ring to compress boot; then, remove circlip out of drive shaft groove1 2