Bombardier SeaDoo 2000 factory shop manual volume 2, Page 273Get this manual
Section 10 PROPULSION SYSTEM Subsection 02 (JET PUMP)
Install impeller removerinstaller tool into impeller splines and tightenAnti-Rattle System
Install spring no27 on slider no26
F00J08A
1Impeller removerinstaller tool
CAUTION: Make sure thrust washer and bearing are not wedged in shaft grooveTo check, manually pull and push jet pump housing, some axial play must be feltTorque impeller to 110 Nm (81 lbfft) then remove toolsCAUTION: Never use any impact wrench to tighten impellerApply synthetic grease (PN 293 550 010) on impeller splinesInsert new boot no13 and ring no14 to impeller