Bombardier SeaDoo 2000 factory shop manual volume 2, Page 271Get this manual
Section 10 PROPULSION SYSTEM Subsection 02 (JET PUMP)
CAUTION: Never hammer the bearing into its housing
Thrust Washer
Position jet pump housing no7 with the stator vanes on topInsert thrust washer no22 in the stator seat
F00J0BA
F00J0DA
1Press on tool until it stops
CAUTION: This tool have been designed to properly position bearings and seal, thus providing space for lubrication purposesThe tool flanges allow thisIf different pusher type is being used, components must be properly positioned as followsBearing on impeller side must be 1.5 to 2.5 mm (.060.100 in) inside reservoir measured from seal seatBearing on venturi side must be to mm (.080.120 in) inside reservoir measured from thrust washer seatRefer to following illustration