Bombardier SeaDoo 2000 factory shop manual volume 2, Page 266Get this manual
Section 10 PROPULSION SYSTEM Subsection 02 (JET PUMP)
To remove impeller, apply rotating movement and pull at same timeSlide impeller out of housingRemove tool from impeller
Impeller Shaft
Remove shaft holder toolRemove impeller shaft no21 with thrust washer and thrust bearing
Wear Ring
Place jet pump housing in vise with soft jawsIt is best to clamp housing using lower earRemove wear ring screwsCut wear ring at two placesNOTE: Wear ring can be cut using jigsaw, small grinder or low clearance hacksaw such as Snapon HS3 or equivalentCAUTION: When cutting ring, be careful not to damage jet pump housing
Seal and Needle Bearing