Bombardier SeaDoo 2000 factory shop manual volume 2, Page 238Get this manual
Section 09 ELECTRICAL SYSTEM Subsection 04 (STARTING SYSTEM)
GENERAL
Causes of troubles are not necessarily related to starter but may be due to burnt fuse, faulty battery, startstop switch, safety lanyard switch, MPEM, solenoid, electrical cables or connectionsCheck these components before removing starterConsult also the starting system troubleshooting table on next page for general view of possible problems
Engine StartStop Switch and Safety Lanyard Switch
Refer to IGNITION SYSTEM or ENGINE MANAGEMENT
Solenoid
NOTE: Solenoid is located in the electrical boxInspect connections and clean as necessaryStatic Test: Continuity With multimeter, check primary winding resistanceIt should be approximately ohmsThere should be no continuity between the positive posts of the solenoidDynamic Test Depress startstop button and measure the voltage on the solenoid positive posts with multimeterIf there is no voltage and battery is in good condition, replace the solenoid