Bombardier SeaDoo 2000 factory shop manual volume 2, Page 215Get this manual
Section 08 LUBRICATION SYSTEM Subsection 03 (OIL INJECTION PUMP)
DI Models Use the VCK (Vehicle Communication Kit) PN 529 035 676Look in the Monitoring section of the software B.U.D.S Use the "Oil lines bleeding" function that allows to "lock" the engine RPM in idle speed while the throttle is fully depressed to ease the bleeding operationAll Models CAUTION: If watercraft is out of water, engine must be cooled using the flush kit
CHECKING OPERATION
On Watercraft
NOTE: Oil line supply must be full of oilSee bleeding procedure aboveStart engine and run at idle while holding the pump lever in fully open positionOil must advance into small oil linesNOTE: The engine should have rich mixture, idling irregularly and emitting smoke at exhaust outletIf not, remove pump assembly and check the pump shaft for defects, replace as necessaryTest pump as describes below: NOTE: Through normal use, oil level must not drop in small tubesIf oil drops, verify check valve operationReplace as necessary4 3
F01G02A