Bombardier SeaDoo 2000 factory shop manual volume 2, Page 213Get this manual
Section 08 LUBRICATION SYSTEM Subsection 03 (OIL INJECTION PUMP)
NOTE: The following procedures can be done without removing the engine from hull
REMOVAL
Pump Cable
The cable end has slight press fit in the leverUsing small screwdriver, pry cable end out
Oil Injection Pump
Remove tuned pipe headRefer to EXHAUST SYSTEM
DISASSEMBLY
NOTE: Some oil pump parts are not available in single partsA gasket set is available for the pumpIf the pump is found defective, it should be replaced by new oneF12G03A
CLEANING
Discard all seals and O-ringsClean metal components in solvent
ASSEMBLY
Oil Injection Pump and Shaft