Bombardier SeaDoo 2000 factory shop manual volume 2, Page 204Get this manual
Section 07 FUEL SYSTEM Subsection 04 (CARBURETOR)
ADJUSTMENTS
Twin Carburetor Synchronization
With idle speed screw not touching throttle lever stopper on MAG carburetor, both throttle plates are in closed position
Tighten jam nuts and torque to Nm (27 lbfin)NOTE: Grease carburetor linkage at both ends with synthetic grease (PN 293 550 010)Connect linkage between both carburetor leversEnsure both throttle plates are still in closed positionNOTE: The linkage installation is done with the marks located near PTO carburetor throttle lever to ease adjustment if to be performed in the watercraft
F01F31A
TYPICAL 1Stopper 2Idle speed screw
Loosen jam nuts on carburetor linkage and adjust linkage with adjustment nutMake sure threads length is the same on each side of linkage and flat surfaces of both ends are parallel with each other1