Bombardier SeaDoo 2000 factory shop manual volume 2, Page 200Get this manual
Section 07 FUEL SYSTEM Subsection 04 (CARBURETOR)
Internal Fuel Filter
To verify condition of filter no5, proceed as follows: Remove pump cover no16, gasket no17, diaphragm no18 and then pump body no4 and diaphragm no19Remove filter no5 from carburetor body then clean filter and blow carefully with compressed air (low pressure)Replace filter if damaged
Obstruct outlet nipple with finger and hold while pumping Pump tester until it reaches 28 kPa (4 PSI)1 3
F06F07A
1Pump gauge tester 2Hose installed to inlet nipple 3Outlet nipple obstructed
F01F0YA
TYPICAL 1Filter
Fuel Accelerator Pump