Bombardier SeaDoo 2000 factory shop manual volume 2, Page 196Get this manual
Section 07 FUEL SYSTEM Subsection 03 (AIR INTAKE)
Air Intake Silencer
Make sure that gaskets no5 are installed into carburetor holes of air intake silencer or throttle bodies on DI modelsCheck O-rings no6 on carburetor intake adaptors or throttle bodies on DI models and change them if necessaryNOTE: Apply Super Lube grease (PN 293 550 014) to mating surface of air intake silencer no1Install air intake silencer on carburetor intake adaptor or throttle bodies on DI models and latch in placeDI Models Ensure the elbow adaptor is well inserted and that it has not pushed the gasket inside the air boxAll Models NOTE: Make sure the air intake silencer is retained by the lower bracket no4Place protector pads on duct supportsUse slot in rubber to insert pad on bracket eyeletSide tongue of protector pad should be toward outside of vehicle and bent downward toward the exhaust flangePut air ducts in intake adapters and secure them on duct supports with hexagonal screws no7, wide washersnarrow washers and elastic stop nutsA slight lift will be required to make the bolts line up with bracketsF06F0VA