Bombardier SeaDoo 2000 factory shop manual volume 2, Page 192Get this manual
Section 07 FUEL SYSTEM Subsection 02 (FUEL CIRCUIT)
NOTE: The system must maintain pressure of 34 kPa (5 PSI) during 10 minutesNever pressurize over 34 kPa (5 PSI)Reconnect air inlet hose of fuel tank to bodyRE OU
WARNING
If any leak is found, do not start the engine and wipe off any fuel leakageDo not use electric powered tools on watercraft unless system has passed pressure testNOTE: Before removing the hose pincher, block with your finger the outlet fitting to feel if air is coming out when removing hose pincherThis will indicate that pressure relief valve and the outlet fitting are not blockedRemove hose pincher from fuel tank vent hose
F01F0KA
TYPICAL CARBURETOR-EQUIPPED MODELS 1Disconnect air inlet hose 2Install hose pincher to vent hose