Bombardier SeaDoo 2000 factory shop manual volume 2, Page 134Get this manual
Section 05 ENGINE MANAGEMENT (DI) Subsection 03 (COMPONENT INSPECTION AND ADJUSTMENT)
If reed valve is found defective, it is suggested to replace it then to temporarily reassemble the compressor to then make pressure testIf it fails, check bottom endWhen changing reed valve, ensure to position ring plate opening so that holes align inside the openingHoles must not be obstructed by the opening edges
Ensure to position screw from the bottom up as showTorque nut to 2.7 Nm (24 lbfin)2.7 Nm (24 lbfin)
F12D0BA
1Screw from bottom up
F12R04A
1Reed valve opening 2Rotate opening to align holes inside without obstructing the holes