Bombardier SeaDoo 2000 factory shop manual volume 2, Page 104Get this manual

Section 04 ENGINE Subsection 06 (BOTTOM END)
Check stopper distance from center of reed valve block
To properly position the outer bearing(s), distance gauge must be temporarily installed against the inner bearingSlide the outer bearing until stopped by the distance gauge, then remove itENGINE 947 DISTANCE GAUGE PN 529 035 100 (MAG) PN 529 035 000 (PTO) 7.5 mm (.295 in)

F06D1EA

F01B0HA

A13 0.25 mm (.512 .010 in)

1Distance gauge

NOTE: Distance should be the same on both sidesBent stopper as required to obtain the proper distance

• ATV
• Jet Ski
• Outboard Motors
• Personal Watercraft
• Snowmobiles
• Stern Drives