Bombardier SeaDoo 2000 factory shop manual volume 2, Page 103Get this manual
Section 04 ENGINE Subsection 06 (BOTTOM END)
Using feeler gauge, measure distance between thrust washer and crankshaft counterweightF01J0ZA
F01D1WA
Close puller claws so that they can be inserted in end bearingHolding claws, turn puller shaft clockwise so that claws open and become firmly tight against bearingSlide puller hammer outwards and tap puller endRetighten claws as necessary to always maintain them tight against bearingContinue this way until bearing completely comes outFor installation, see below in this section
1Measuring big end axial play 2Feeler gauge
Reed Valve
Check reed valve petals no29 for cracks or other defectsThe reed petals must lie completely flat against the reed valve body no30To check, hold against light