Bombardier SeaDoo 2000 factory shop manual volume 2, Page 91Get this manual
Section 04 ENGINE Subsection 05 (TOP END)
Cylinder Base Gasket
Install new base gasketNOTE: The general procedure is to install new gasket of the same thicknessHowever, if you do not know the gasket thickness that was installed or if crankshaft andor crankcase repair or replacement was involved, refer to the COMBUSTION CHAMBER VOLUME MEASUREMENT to properly determine the required gasket thicknessFive thicknesses of cylinder base gaskets are available for precise adjustment of the squish gapTo identify gasket thickness, refer to the identification holes on the gasket
To easily slide cylinder block over pistons, use ring compressor (PN 290 876 965)
A01B1TA
1Slide this edge
NOTE: For each ring, make sure to align ring end gap with piston locating pinInstall cylinder block947 DI Engines
Cylinder Block
947 Carburetor-Equipped Engines Install studs no32Apply Loctite 243 to threads and torque studs to 15 Nm (11 lbfft)Refer to exploded view to see what end to insert in crankcaseRemove O-rings from studsAll Engines Install cylinder base gasket no10There is only one way to install gasketThe cylinder block is positioned with locating dowelsLine up dowels with corresponding holes in cylinder block1