Bombardier SeaDoo 2000 factory shop manual volume 2, Page 85Get this manual
Section 04 ENGINE Subsection 05 (TOP END)
Inspect plane surfaces for warpageSmall deformation can be corrected by grinding surface with fine sand paperInstall sand paper on surface plate and rub part against oiled sand paperThe inspection of engine top end should include the following measurementsENGINE MEASUREMENT Cylinder taper Cylinder out of round Pistoncylinder wall clearance for 947 carburetorequipped engine Pistoncylinder wall clearance for 947 DI engine Ringpiston groove clearance for 947 carburetorequipped engine Ringpiston groove clearance for 947 DI engine Ring end gap for 947 carburetorequipped engine Ring end gap for 947 DI engine
N.A Not Applicable
TOLERANCES NEW PARTS (min (max N.AN.A0.05 mm (.002 in) 0.008 mm (.0003 in) WEAR LIMIT 0.1 mm (.004 in) 0.08 mm (.003 in) 0.20 mm (.008 in)
0.09 mm (.0035 in)
F01D8AA
0.12 mm (.0047 in)
0.20 mm (.008 in)
1Measuring perpendicularly (90to piston pin axis 2Auxiliary transfer port A16 mm (58 in)