Bombardier SeaDoo 2000 factory shop manual volume 2, Page 82Get this manual
Section 04 ENGINE Subsection 05 (TOP END)
947 DI Engines Use Snap-On Torx socket E12 and unscrew cylinder head screws no14 following the sequence shown in the next illustration1 11 10 12 3
F06D0ZA
1Remove cylinder block
F12D08B
Remove cylinder head no2 and gasket no34
NOTE: To ease removal, plastic tip hammer can be usedRemove cylinder base gasket no10947 DI Engines Remove cylinders screws then cylinders no9All Engines
Cylinder
NOTE: When removing cylinder, be careful that connecting rods do not hit crankcase edge947 Carburetor-Equipped Engines Remove studs no32Take two head cover nutsScrew nuts onto studLock both nuts together and unscrew the studRepeat this operation for the other studsNOTE: Studs must be removed prior cylinder block