Bombardier SeaDoo 2000 factory shop manual volume 2, Page 72Get this manual
Section 04 ENGINE Subsection 04 (MAGNETO SYSTEM)
CLEANING
Clean all metal components in solventCAUTION: Clean coils and magnets using only clean clothClean crankshaft taper and threads using acetoneApply the acetone on rag first then clean the crankshaft
ASSEMBLY
Stator and Trigger CoilCPS (Crankshaft Position Sensor)
F06D0PA
TYPICAL 1Puller
Tighten puller screw and at the same time, tap on screw head using hammer to release engine flywheel from its taperCAUTION: Be careful after flywheel removal not to bend the encoder wheel teethAlso pay attention when putting awayIf you suspect bent tooth, refer to ENGINE MANAGEMENT for inspection procedure