Bombardier SeaDoo 2000 factory shop manual volume 2, Page 66Get this manual
Section 04 ENGINE Subsection 03 (REMOVAL AND INSTALLATION)
INSTALLATION
Installation of engine in watercraft is essentially the reverse of removal proceduresHowever pay particular attention to the following
Rubber Mount, Shim and Screw
Check tightness and condition of rubber mountsIf they have been removed, apply Loctite 243 (blue) on screw threadsTorque screws to 25 Nm (18 lbfft)CAUTION: Strict adherence to this torque is important to avoid damaging threads of aluminum insert in bilge
Engine Support
Apply Loctite 243 (blue) to rear engine support screws and torque to 25 Nm (18 lbfft)F00B0FA
1Plate 2Support
Alignment shaft (PN 295 000 141)
F00B0GA
1Alignment shaft