Bombardier SeaDoo 2000 factory shop manual volume 2, Page 63Get this manual
Subsection 03
Section 04 ENGINE (REMOVAL AND INSTALLATION)
REMOVAL AND INSTALLATION
GENERAL
On DI models, it is not necessary to remove engine from watercraft to service TOP END, PTO FLYWHEEL or MAGNETOHowever, engine removal is necessary to repair BOTTOM END
ENGINE REMOVAL
DI Models Use the VCK (Vehicle Communication Kit) (PN 529 035 676) and release the fuel pressure in the fuel systemRefer to ENGINE MANAGEMENT sectionAll Models In order to remove engine from watercraft proceed as followsDisconnect battery cables from battery
DI Models Disconnect throttle position sensors (TPS), manifold air pressure sensor (MAPS) and manifold air temperature sensor (MATS)Disconnect connectors from fuel injectors and direct injectorsDisconnect connector from knock sensorDisconnect RAVE valve hose where shownInspect hoseIf it has hardened, replace hose1
WARNING
Always disconnect battery cables exactly in the specified order, BLACK negative cable first then the RED positive battery cable lastF12D02A