Bombardier SeaDoo 2000 factory shop manual volume 2, Page 50Get this manual
Section 03 TROUBLESHOOTING Subsection 01 (TROUBLESHOOTING CHART)
ENGINE WILL NOT START (cont'd)
OTHER OBSERVATION POSSIBLE CAUSE Faulty component in the fuel injection system (DI models) Engine drowned mode is active Low battery voltage Low or no fuel pressure (DI models) REMEDY Check for fault codes with the VCK (vehicle communication kit)Refer to Diagnostic Procedures in ENGINE MANAGEMENT Release throttle lever Recharge or replace battery Check fuel pump operation Check fuel pump pressure output Check airfuel rail Check fuel injector operationReplace as necessary Check output signal from MPEM Check airfuel rail Check air compressor system Check RAVE valve system for leaks Check direct injector operation Check output signal from MPEM Check spark plugs condition and replace as necessary Check ignition system and repair Replace MPEM Check operation of CPS and replace if necessary Checksiphon and refill Cleanreplace Check, refer to section MAINTENANCE Check, refer to section FUEL SYSTEM Check, refer to section ELECTRICAL SYSTEM Check wiring harness and replace fuse Check, refer to section FUEL SYSTEM and COOLING SYSTEM on DI models Check, refer to sections ENGINE Check timing mark, refer to section ELECTRICAL SYSTEM Replace MPEM Replace MPEM