Bombardier SeaDoo 2000 factory shop manual volume 2, Page 40Get this manual
Section 02 MAINTENANCE Subsection 03 (FLUSHING AND LUBRICATION)
Carburetor-Equipped Models
F07E01B
F02F1VA
1Garden hose installed 2Quick connector adaptor
Start the engine then immediately open the water tap
1Air intake silencer 2Spray BOMBARDIER LUBE here
WARNING
Do not touch any electrical parts or jet pump area when engine is runningCAUTION: Never flush hot engineAlways start the engine before opening the water tapOpen water tap immediately after engine is started to prevent overheatingRun the engine about minutes at fast idle around 3500 RPMEnsure water flows out of drain lines (engine crankcase, engine cylinder and air compressor (DI models)) while flushingOtherwise, clean the linesCAUTION: Never run engine longer than minutesDrive line seal has no cooling when watercraft is out of waterSpray BOMBARDIER LUBE lubricant where shown keeping engine at fast idle for approximately one minute