Bombardier SeaDoo 2000 factory shop manual volume 1, Page 441Get this manual
Section 14 WIRING DIAGRAMS Subsection 01 (WIRING DIAGRAMS)
CAUTION: Do not pierce the diaphragm with sharp point for electrical troubleshootingThe resulting pinholes in the insulation will allow moisture to penetrate the system and possibly result in system failure
Contact Installation
For insertion of signal contact, make sure the wedge lock is in the open positionNOTE: For insertion of power contact, the wedge lock may or may not be on the open positionInsert contact into appropriate circuit cavity and push as far as it will goPull back on the contact wire to be sure the retention fingers in the housing are holding the contact properlyAfter all required contacts have been inserted, the wedge lock must be closed to its locked position