Bombardier SeaDoo 2000 factory shop manual volume 1, Page 437Get this manual
Section 14 WIRING DIAGRAMS Subsection 01 (WIRING DIAGRAMS)
Pull back on the contact wire to be sure the retention fingers are holding the contact After all required contacts have been inserted, the lock must be installed
V01G0PA
F04H6LA
MALE HOUSING 1Male lock
NOTE: Before extraction, push wire forward to relieve pressure on retaining tab Insert 4.8 mm (0.189 in) wide screwdriver blade inside the front of the contact cavity Pry back the retaining tab while gently pulling wire back until contact is removed1