Bombardier SeaDoo 2000 factory shop manual volume 1, Page 405Get this manual
Subsection 02
Section 12 HULLBODY (ADJUSTMENT AND REPAIR)
Apply Loctite 243 (blue) on sponson studsInstall sponsons no6 on hullFrom inside bilge, first insert flat washers no8 over sponson studsSecure with lock nuts no10Tighten to Nm (44 lbfin)NOTE: To ease flat washer and lock washer installation, use flexible 4-claw Snap-on pick-up tool
F01L4GA
TYPICAL 1Front bumper 2Corner bumper 3Straight section 4Bow section
4Slide bumper rail no4 under front bumper no135Using 4.80 mm (316 in) drill bit, drill first hole through bumper rail no4 at front of bow sectionUse locating mark as guideThen install rivet no12CAUTION: When drilling, be careful not to damage bumper rail andor hull6Position bumper rail no4 properly onto body and cut excess length if necessary7Slide bumper rail no4 in corner bumper no148Using hole positions previously marked on body, drill holes in bumper rail no4 and install rivets no129Install trim no5 using soapy water10Repeat procedure for the other side