Bombardier SeaDoo 2000 factory shop manual volume 1, Page 401Get this manual
Subsection 02
Section 12 HULLBODY (ADJUSTMENT AND REPAIR)
JET PUMP SUPPORT
All Models Except GTS
Removal
Remove jet pumpRefer to JET PUMPRemove inlet grate and riding plateRemove ball joint, boot, nut, half rings and O-rings from steering cable
Using heat gun, heat jet pump support until it is possible to pull itNOTE: Shims may have been installed between support and bodyDo not remove these shims, otherwise jet pump alignment will be altered
Installation
Apply Loctite The Right Stuff Gasket as indicated by the shaded areas in the next illustrationsFollow also the torquing sequence as shown in the same illustrations1 2