Bombardier SeaDoo 2000 factory shop manual volume 1, Page 367Get this manual
Section 10 STEERING SYSTEM Subsection 02 (STEERING SYSTEM)
Remove retaining block no20
F08K0MA
F08K0KA
1Apply synthetic grease
1Cable Support 2Remove M6 bolts
Steering Stem Arm and Support
Position steering stem arm no15 and support no16 onto steering stem no14
Disconnect ball joint no21 of steering cable from jet pump nozzleRemove ball joint no21, jam nut no22 and boots no23 and no24Loosen nut no25 and remove half rings no26 and O-ring no27NOTE: To loosen nut, use steering cable tool (PN 295 000 145)Remove steering cable from watercraft
WARNING
Make sure integrated flat keys of steering stem arm and support are properly seated in steering stem keyways