Bombardier SeaDoo 2000 factory shop manual volume 1, Page 349Get this manual
Section 09 PROPULSION SYSTEM Subsection 05 (VARIABLE TRIM SYSTEM)
GENERAL
To test VTS control module, motor or switch, refer to INSTRUMENTS AND ACCESSORIESTo have access to VTS module, remove seat (except XP)NOTE: On XP model, open rear access coverRemove screws retaining electrical box and move it aside (on GSX RFI only)
All Models Disconnect wiring harnessesPull out VTS assembly no6 from bilge
DISASSEMBLY
Remove VTS cover no7 by pressing on tabsREMOVAL
Remove nut no15 and bolt no13 retaining ball joint no1 to sliding shaftRemove clamps no2Remove boot no32 3