Bombardier SeaDoo 2000 factory shop manual volume 1, Page 334Get this manual
Section 09 PROPULSION SYSTEM Subsection 03 (DRIVE SYSTEM)
Place grease fitting on the top and torque seal carrier nuts no21 in criss-cross sequence in steps as per following illustrationNOTE: It is very important to tighten nuts of seal carrier in criss-cross sequence to maintain its alignment1 6
Insert drive shaft through carbon ring no8 and floating ring no6Insert drive shaft through seal carrier no14 being careful not to damage sealsCAUTION: When sliding the drive shaft through seal carrier, the double lip seal can be folded overThis would cause seal carrier bearing failureReinstall protective plate no18Apply Loctite 243 (blue) on bolts and torque lock nuts to 10 Nm (88 lbfin)All Models Except the XP
Drive Shaft and Dampers
Install dampers no13 on drive shaft no12NOTE: Make sure dampers were not left in PTO flywheel or impellerInstall drive shaft and jet pump at the same timeInsert drive shaft through carbon ring no8 and floating ring no6NOTE: Make sure to install floating ring before inserting the drive shaft in the PTO flywheelWhile holding jet pump, guide and engage drive shaft splines in PTO flywheelRotate shaft to properly index splinesMake sure boot is well positioned over shaft endAll Models