Bombardier SeaDoo 2000 factory shop manual volume 1, Page 327Get this manual
Section 09 PROPULSION SYSTEM Subsection 03 (DRIVE SYSTEM)
All Models Except the XP
Drive Shaft
Simply pull out drive shaftNOTE: If the drive shaft is jammed into PTO flywheel, make the following tool and use it in conjunction with the jet pump housing remover (PN 295 000 113) to withdraw drive shaftF01B1TA
To open clamp, place flat side of plier on clamp embossment, squeeze and twist plier
Raw Material: aluminum alloy square of 51 mm (2 in) 305 mm (12 in) aluminum rods of 28.5 mm (1-18 in) diax 30 mm (1-316 in)2 C
F02J0PA
Circlip and Floating Ring