Bombardier SeaDoo 2000 factory shop manual volume 1, Page 320Get this manual
Section 09 PROPULSION SYSTEM Subsection 02 (JET PUMP)
Apply Loctite 518 (Gasket Eliminator) on mating surfacePosition venturi no11 with bailer passages on topApply Loctite 243 (blue) on threads of screws no12NOTE: On the GTI and GTX models, install the reverse support with the venturiInstall screws no12, lock washers no13 and flat washers no14 then torque to 21 Nm (16 lbfft)PUMP PRESSURIZATION
Whenever doing any type of repair on jet pump, pressure test should be done to check for leakageProceed as follows: Remove drain plug from cover Apply Loctite PST 592 on threads of fitting tool (PN 295 000 086) then secure on cover Connect pump gauge tester (PN 295 000 085) to fitting Pressurize pump to maximum of 70 kPa (10 PSI)
F02J0TA
F00J0LA
1Torque screws to 21 Nm (16 lbfft)