Bombardier SeaDoo 2000 factory shop manual volume 1, Page 315Get this manual
Section 09 PROPULSION SYSTEM Subsection 02 (JET PUMP)
Bearing on impeller side must be 1.5 to 2.5 mm (.060.100 in) inside reservoir measured from seal seatBearing on venturi side must be to mm (.080.157 in) inside reservoir measured from thrust washer seatRefer to following illustration
F01J1HA
1Stamped end this side
CAUTION: Never hammer the bearing into its housing
F01J1JA
Seal seat Stamped end of bearing Thrust washer seat Stamped end of bearing 1.52.5 mm (.060.100 in)mm (.080.157 in)