Bombardier SeaDoo 2000 factory shop manual volume 1, Page 307Get this manual
Section 09 PROPULSION SYSTEM Subsection 02 (JET PUMP)
All Models Except GTS Disconnect steering cable from jet pump nozzleLoosen hexagonal nuts no6 and remove flat washers and lock washers from jet pump housingRemove jet pump with wiggle movementGTS Model Disconnect steering cable from jet pump nozzleRemove nozzleLoosen hexagonal nuts no6 and remove flat washers and lock washers from jet pump housingUsing screws previously removed from nozzle, install jet pump housing remover tool (PN 295 000 113) on venturi
DISASSEMBLY
NOTE: Whenever removing part, visually check for damage such as: corrosion, crack, split, break, porosity, cavitation, deformation, distortion, heating discoloration, wear pattern, missing plating, missing or broken needles in needle bearing, water damage diagnosed by black-colored spots on metal parts, etcRenew any damaged partAs quick check, manually feel clearance and end play, where applicable, to detect excessive wearGTS Model
Pump Fitting
Pump fittings can be removed with deep socket or vise gripDo not contact hose mounting areaFittings can be removed from pump housing with the following suggested tool: Use 14 mm (916 in) deep socket Drill deep socket with 14 mm (916 in) drill bit, starting at hexagon head end as shown in following illustration Drill 2.40 mm (332 in) hole in center of deep socket as shown in following illustration Install 2.40 mm (332 in) roll pin in the center holeF01J5JA