Bombardier SeaDoo 2000 factory shop manual volume 1, Page 285Get this manual
Section 08 ELECTRICAL SYSTEM Subsection 04 (STARTING SYSTEM)
947 Engine Install new O-rings and gasketsInsert thrust washers no19 onto armature shaft
Screw and Teeth Washer
Apply Loctite 271 (red) to screwConnect BLACK negative cable to starter using flat washer, teeth washer no15 and screw no14Torque screw to 22 Nm (16 lbfft)Apply dielectric grease on terminal and screw
F06H1HA
F01H1JC
1Thrust washers
Install the three washers no8 onto armature shaftWhen installing end covers no3 and no10 to yoke, align index marksApply Loctite 271 (red) on through bolts no5 and torque to Nm (53 lbfin)
717 ENGINE SHOWN Step Step Step Step
STARTER INSTALLATION
Installation is essentially the reverse of removal procedureHowever, pay particular attention to the followingMake sure that starter and engine mating surfaces are free of debrisSerious trouble may arise if starter is not properly aligned717 Engine