Bombardier SeaDoo 2000 factory shop manual volume 1, Page 282Get this manual
Section 08 ELECTRICAL SYSTEM Subsection 04 (STARTING SYSTEM)
Release brush wires of yoke from brush holder no2Remove brush holder no2
Remove brushesTo remove bearing and seal in end cover, release tabs of retainerF06H1MA F06H1KA
1Retainer
1Remove brush holder
To remove brushes from yoke no1, loosen nut and remove washers
CLEANING
CAUTION: Yoke ass'y and drive unit assembly must not be immersed in cleaning solventDiscard all O-ringsClean brushes and holders with clean cloth soaked in solventBrushes must be dried thoroughly with clean clothBlow brush holders clean using compressed air