Bombardier SeaDoo 2000 factory shop manual volume 1, Page 268Get this manual
Section 08 ELECTRICAL SYSTEM Subsection 03 (CHARGING SYSTEM)
DYNAMIC TEST 1Disconnect the magneto wiring harness connector2Install the 4-pin magneto harness adapter (PN 295 000 131)3Connect test probes of the multimeter to the YELLOW and YELLOWBLACK wires of the 4-pin magneto harness adapter4Start and rev engine to 3500 RPMThe obtained value should be between 25 and 40 Vac5If the battery charging coil is out of specification, replace it
STATIC TEST: INSULATION 1Disconnect the magneto wiring harness connector2Install the 6-pin magneto harness adapter (PN 295 000 136)3Insert multimeter positive (+) probe to one of the YELLOW wire of the 6-pin magneto harness adapter4Ground the multimeter negative (-) probe to the engine or the stator iron core and note the reading4 1
947 Engine STATIC TEST: CONTINUITY 1Disconnect the magneto wiring harness connector2Install the 6-pin magneto harness adapter (PN 295 000 136)3Check resistance between two of the YELLOW wiresThe resistance should be between 0.1 to 1.0 ohm3 1
1234F01H60A