Bombardier SeaDoo 2000 factory shop manual volume 1, Page 243Get this manual
Section 07 LUBRICATION SYSTEM Subsection 03 (OIL INJECTION PUMP)
CHECKING OPERATION
On Watercraft
NOTE: Oil line supply must be full of oilSee bleeding procedure aboveStart engine and run at idle while holding the pump lever in fully open positionOil must advance into small oil linesNOTE: The engine should have rich mixture, idling irregularly and emitting smoke at exhaust outletIf not, remove pump assembly and check the pump gear (717 engine) or shaft (787 RFI and 947 engines) for defects, replace as necessaryTest pump as describes below: NOTE: Through normal use, oil level must not drop in small tubesIf oil drops, verify check valve operationReplace as necessary
F07G02A
787 RFI ENGINE 1Bleed screw
Keep bleeding until all air has escaped from lineMake sure no air bubbles remain in oil supply lineTighten bleed screwWipe any oil spillageCheck small oil lines of pumpThey must be full of oil1