Bombardier SeaDoo 2000 factory shop manual volume 1, Page 226Get this manual
Section 06 FUEL SYSTEM Subsection 05 (FUEL INJECTION)
REMOVAL AND INSTALLATION THROTTLE POSITION SENSOR (TPS)
Remove the air intake silencerRemove the flame arresterRemove the air temperature sensor to ease removal of the TPSDisconnect the connector of the TPSLoosen Allen screws retaining the TPSRemove TPS
FUEL PUMP ASSEMBLY
Open the front storage compartment coverRemove the storage basketRemove the glove boxDisconnect the wire connector from the fuel pump assemblyDisconnect fuel vent hose from fuel pump assemblyCover the quick connect fitting with shop towelPress on both tabs and disconnect the quick connect fitting
AIR TEMPERATURE SENSOR (ATS)
Remove the air intake silencerRemove the flame arresterDisconnect the connector of the ATSPull the ATS from the grommet retaining it
WARNING
Fuel is under pressureWipe off any fuel spillage in the bilgeFuel is flammable and explosive under certain conditionsAlways work in well ventilated areaLoosen nuts retaining the fuel pump assembly to the fuel tankAIR PRESSURE SENSOR (APS)